There are some brand that only offer assemblies even if you just need a cover so be prepared for that. If you need just a cover You would measure the overall outside and inside dimensions of the cover and the height as well as the brand and screw configuration and compare them to our covers. To figure out what size of a return assembly you would need if you were replacing the whole assembly you would measure the pipe size and the hole size through the shell. USING THE HOT TUB WITH THESE MISSING COULD CAUSE A PERSON TO DROWN BY BEING HELD UNDER THE WATER BY THE SUCTION PRESSURE OF A PUMP SO DON’T TAKE A MISSING OR BROKEN COVER LIGHTLY! NOTE: THESE COVERS ARE VERY IMPORTANT AND IF THEY ARE MISSING OR COMPROMISED YOU SHOULD NOT USE THE HOT TUB UNTIL THEY ARE REPLACED. Things that go wrong with Suctions are people stepping on the cover and breaking them off or the cover just getting fatigued and breaking apart or leaks where the suction is sealed through the shell to the plumbing system. This is where the pumps suck the water along with the filter into the pumps to push through the manifold system back to the jets. This Part is found normally in the footwell of your Hot Tub and has a cover over it with a bunch of small holes or slits cast in it. In this Category you will find Suction or some people call them Return Parts.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |